Foxconn 45CMX - Usb Device Setting

35
3
► Onboard FDC Controller
This item is used to enable or disable the onboard FDC controller.
► Onboard Serial Port 1
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► Onboard Serial Port 2
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 2.
► UART Mode Select

[Normal] : a RS232 device. (optional)


► IrDA Duplex Mode
This item enables you to determine the infrared function of the onboard infrared chip.
► Onboard Parallel Port
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard parallel
(or Printer) port.
► Parallel Port Mode
This item is used to select the operation modes for the onboard parallel (or Printer) port. They
are [SPP], [EPP], [ECP] and [ECP/EPP].
USB Device Setting
► USB 1.1 Controller
This item is used to enable or disable the Universal Host Controller Interface for USB.
► USB 2.0 Controller
This item is used to enable or disable the Enhanced Host Controller Interface for USB.
Phoenix - AwardBIOS CMOS Setup Utility
USB Device Setting
USB 1.1 Controller [Enabled] Item Help
   [Enabled]
USB Operation Mode [High Speed] 
USB Keyboard Function [Enabled]
USB Mouse Function [Enabled] [Enable] or [Disable]
USB Storage Function [Enabled] Universal Host
Controller
*** USB Mass Storage Device Boot Setting *** Interface for Universal
Serial Bus


Enabled