Foxconn A74MX-K - Superio Configuration; Onboard Floppy Controller

3
36
SuperIO Conguration
► OnBoard Floppy Controller
This item is used to enable/disable Floppy Controller.
► Serial Port 1 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port .
► IR Address
This item is used to assign the I/O address and interrupt request (IRQ) for the IR port.
► IR Mode
This item is used to set the IR mode. The available settings are :
[IrDA] : An IrDA device for maximum 115200 bit/s.
[AS� IR] : A faster IrDA for 1152000 bit/s.
► IR Duplex Mode
This item enables you to determine the infrared function of the onboard infrared chip.
► Parallel Port Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard parallel
port .
► Parallel Port Mode
This item is used to set parallel port mode.
► Parallel Port IRQ
This item is used to assign interrupt request (IRQ) for the onboard parallel port .
CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc.
SuperIO Conguration
SuperIO Conguration Help Item
OnBoard Floppy Controller [Enabled] Allows BIOS to Enable
Serial Port1 Address [3F8/IRQ4] or Disable Floppy[3F8/IRQ4] or Disable Floppy or Disable Floppy
IR Address [2F8/IRQ3] Controller.
IR Mode [IrDA] IR Mode [IrDA]IR Mode [IrDA]
I IR Duplex Mode [Half Duplex]
Parallel Port Address [378][378]
Parallel Port Mode [Normal]
Parallel Port IRQ [IRQ7]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled]