2
1. Notes on This Manual
1.1 Scope of Validity
This manual describes the assembly, installation, commissioning, maintenance and troubleshooting of
the following model(s) of Fox ESS products:
H1- 3.0-E H1- 3.7-E H1- 4.6-E H1- 5.0-E H1- 6.0-E H1-4.6-E1 H1-5.0-E1
AC1- 3.0-E AC1- 3.7-E AC1- 4.6-E AC1- 5.0-E AC1-6.0-E AC1-4.6-E1 AC1-5.0-E1
Note: Please keep this manual where it will be accessible at all times.
Version number: V1.30
1.2 Target Group
This manual is for qualified electricians. The tasks described in this manual only can be performed by
qualified electricians.
1.3 Symbols Used
The following types of safety instructions and general information appear in this document as described
below:
Danger!
“Danger” indicates a hazardous situation which, if not avoided, will result in death or
serious injury.
Warning!
“Warning” indicates a hazardous situation which, if not avoided, could result in death
or serious injury.
Caution!
“Caution” indicates a hazardous situation which, if not avoided, could result in minor
or moderate injury.
Note!
“Note” provides important tips and guidance.
This section explains the symbols shown on the inverter and on the type label:
Symbols Explanation
Symbol Explanation CE mark. The inverter complies with the requirements of the
applicable CE guidelines.
This mark indicates compound UK product safety certification requirements.
Beware of hot surface. The inverter can become hot during operation. Avoid contact
during operation.
Danger of high voltages.
Danger to life due to high voltages in the inverter!
To Next Page
Loading...
