6.4 Installation Steps
· Mounting
STEP-1
Measure and confirm that the bottom of the bracket is 285mm away from the ground, and mark the 5-hole
positions on the bracket with a pen.
STEP-2
Drill holes with electric drill, make sure the holes are deep enough (at least 50mm) for installation, and then
tighten the expansion tubes.
STEP-3
Install the expansion tubes in the holes, and tighten them. Then install the wall bracket by using the expansion
screws.
STEP-4
Hang the battery over the bracket, move the battery close to it, lower the battery, and make sure the 2 mounting
bars on the back are fixed well with the 2 grooves on the bracket.
· Wiring
To Next Page
