5.2 Preparation
▪ Please refer to the Technical Data to make sure the environmental conditions fit the inverter’s requirements
(degree of protection, temperature, humidity, altitude, etc.)
▪ Please avoid direct sunlight, rain exposure and snow build-up during installation and operation.
▪ To avoid overheating, always make sure the air flow around the inverter is not blocked.
▪ Do not install in places where gas or flammable substances may be present.
▪ Avoid electromagnetic interference that can compromise the correct operation of electronic equipment.
▪ The slope of the wall should be within ±5°.
5.3 Installation Space Required
To Next Page
Loading...
