FoxESS S700-G2 - Important Notes; Scope; Target Group; Symbols Used

1
1. Important Notes
1.1 Scope
This manual describes the assembly, installation, commissioning, maintenance and troubleshooting
of the following model(s) of Fox ESS products:
S Series (G2):
S700-G2 S1000-G2 S1500-G2 S2000-G2
S2500-G2 S3000-G2 S3300-G2
1.2 Target Group
This manual is for qualified personnel only. The tasks described in this manual will need to be
performed by professional, suitably qualified technicians only.
1.3 Symbols Used
The following types of safety instructions and general information appear in this document as
described below:
Danger!
“Danger” indicates a hazardous situation which, if not avoided, will result in death or
serious injury.
Warning!
“Warning” indicates a hazardous situation which, if not avoided, could result in death
or serious injury.
Caution!
“Caution” indicates a hazardous situation which, if not avoided, could result in minor
or moderate injury.
Note!
“Note” provides important tips and guidance.
1.4 Symbols Explanation
This section explains the symbols shown on the inverter and on the type label:
Symbols
Explanation
Symbol Explanation CE mark. The inverter complies with the requirements of the
applicable CE guidelines.
This mark indicates compound UK product safety certification requirements.
Beware of hot surface. The inverter can become hot during operation. Avoid contact
during operation.