10
1. Press and hold the P1 or P2 button for 5 seconds. Notice the top
status line of the TX9 display will change to: “SEL SND/VOL
PRESS P1” or “SEL SND/VOL PRESS P2”.
2. Use the sound selector buttons to highlight the sound you wish
to have set on the preset.
3. Use the volume buttons to set the desired volume level for the
preset.
4. Push P1 or P2 a final time, depending upon which one you are
setting.
To begin playback of a preset, simply push the P1 or P2 button while
operating the Wildfire 2 remotely. The Wildfire 2 will immediately
switch to that sound and volume level.
3. Auxiliary Jack Function
The Wildfire 2 is equipped with an auxiliary jack labeled “AUX”. The
purpose of this jack is to allow for the connection of certain external
devices, such as the FOXPRO
®
Jack-in-the-Box or Jack-Attack Decoy and
to be able to turn these on and off with the TX9 remote control
transmitter. However, there are some strict electrical limits involved
with this jack. If these limits are exceeded, damage to your Wildfire 2
will result. This damage is not covered by the warranty.
The electrically inclined will want to know that the jack is connected to
the drain of an internal Field Effect Transistor with a maximum current
rating of 100mA. The “tip” polarity of the 3.5mm jack is positive, while
the sleeve is negative. If the external device is connected with the
polarity reversed, an internal protection diode within the FET will
conduct, causing the device to stay on constantly. The maximum
voltage applied to this jack must never exceed 15 volts. Typical uses for
this jack would be to control the FOXPRO
®
Jack-in-the-Box or Jack-
Attack Decoy, or to start and stop a video recorder. Instructions on
To Next Page
Loading...
