Foxpro WILDFIRE - Using External Speakers; Connecting External Speakers; Disabling the Internal Speaker

11
connecting various devices to the “AUX” jack are beyond the scope of
this manual. You are urged to seek help from a knowledgeable
professional before connecting any unapproved device to this jack.
Remember that damage to your Wildfire 2 caused by improper use of
the “AUX” jack is not covered by the warranty, nor will FOXPRO
®
be
liable for damage to any device connected to this jack.
4. Using External Speakers
The Wildfire 2 is equipped with an external speaker jack which allows
you to connect an additional speaker. The internal speaker performs
admirably; however, you may encounter situations that require higher
volume levels. By connecting a larger and more efficient external
speaker to the Wildfire 2, the volume level can be increased
significantly. You can find a complete selection of additional speakers to
purchase on the FOXPRO website.
4-1 Connecting External Speakers
The external speaker jack on your Wildfire 2 accepts a standard 3.5mm
plug. When choosing an external speaker, it is recommended to use one
with an impedance rating of 8-ohms. NOTE: Be sure the Wildfire 2 is
turned OFF before connecting an external speaker. To connect an
external speaker, plug the connector of the external speaker into the
external speaker jack. If you wish to have ONLY the external speaker
produce sound, you must disable the internal speaker as the internal
speaker is not disabled automatically.
4-2 Disabling the Internal Speaker
Move the speaker slide switch to the “OFF” position (to the left) to
disable the speaker. To re-enable the speaker later, simply place the
slide switch back to the “ON” position. By disabling the internal speaker