8
1-4 TX9 Remote: Requirements
The TX9 remote control operates on a single 9V battery. It is
recommended that you use a high-quality alkaline battery.
Installing the Battery in the TX9 Remote
1. Access the battery compartment by removing the door from the
back of the remote. The door slides down and off the remote.
2. Attach the 9V battery to the power wire in the back of the
remote.
3. Slide the battery compartment door back on the remote.
2. Quick Start Guide
We realize that some of you may wish to jump directly into basic
operations, such as playing sounds and using presets. This is a very brief
overview, and it is strongly recommended that you read this manual in
its entirety to fully understand all the capabilities of the system.
2-1 Playing Sounds
Prior to attempting to use the Wildfire 2, make sure that it is turned on.
The Wildfire remote control is not intended to operate the caller at
distances shorter than 1 meter (3 feet). If the remote is located too
close to the caller, proper operation cannot be ensured.
1. Turn on the TX9 remote control by pushing and holding the
power/send button for 2-3 seconds. You will see the LCD panel
light-up and display the sound list.
2. Use the sound up or down arrow button to cycle through the
sound list. Observe the black horizontal selector bar moving up
or down in conjunction with your button presses. When scrolling
through the sounds, the playlist will change by the page. The
first page will display sounds 000 – 005, page two displays 006 –
011, etc.
To Next Page
Loading...