DRAFT v0.3 English, 01 Mar 2012
- 1 -
The PostBase Connectivity Wizard
The PostBase Connectivity Wizard allows you to easily set up your postage meter to suit your
organization’s arrangements. This document will guide you through the steps of the wizard.
Depending on the network configuration in your organization, this may be very straightforward.
However, in some cases, you may need to get information from your network administrator - where
necessary this is indicated in the steps below.
The Connectivity Wizard runs automatically the first time you turn on your PostBase meter. However
you can change any settings at any time later from the main menu (under ‘Manage Connection’).
Section 10 summarizes the information a network administrator may need about the meter; it also
includes a table where you can record the settings you have used.
To Next Page
Need help?
General
