FP Zoom TTL - Advanced Settings and Warnings; Wide Angle Diffusion Panel Usage; Low Battery Indicator; Custom Function (C.Fn) Settings

If the battery power is low, < > will
appear and blink on the LCD panel.
Please replace the batteries
immediately.
19
Using the Wide Angle Diusion Panel
Low Battery Warning
Pull out the wide angle diusion
panel and place it over the ash head
as shown. The ash coverage will then
be expanded to 14 mm.
The catchlight panel will come out
at the same time. Push the
catchlight panel back in.
The < ZOOM/C.FN > button will
not work.
The following table lists the available and unavailable custom
functions of this ash.
1. Press < Zm/C.Fn > Backlight/Custom Setting Button for 2 seconds
or longer until C.Fn menu is displayed. The “Ver x.x” in the top-right
corner refers to the software version.
2. Select the Custom Function No.
Turn the Select Dial to choose the Custom Functions.
3. Change the Setting.
Press < SET > button and the Setting No. blinks.
Turn the Select Dial to set the desired number. Pressing < SET >
4. In the C.Fn mode, long press the “Clear” button for 2 seconds until
“OK” is displayed on the panel, which means the values in C.Fn can
be reset.
C.Fn: Setting Custom Functions
m/ft
APO
AF
Sv APOT
BEEP
LIGHT
LCD
m
ft
ON
OFF
ON
OFF
60min
30min
ON
OFF
12sec
OFF
ON
0~9
meters
feet
ON
OFF
ON
OFF
60min
30min
ON
OFF
O in 12 sec.
Always o
Always lit
10 levels
C.Fn Custom Functions
Custom
Function
Signs
Setting
No.
Settings &
Descriptions
Distance indicator
Auto power o
AF-assist beam
Slave auto power
o timer
Audible
ready alert
Backlighting time
LCD contrast ratio
Function