FP Zoom TTL - Flash Protection Functions; Over-Temperature Protection; Other System Protections and Prompts

20
The system provides real-time protection to secure the device and
your safety. The following lists prompts for your reference:
2. Other Protections
Number of ashes that will activate over-temperature protection:
Number of ashes that will activate over-temperature
protection in high-speed sync triggering mode:
Power Output Level
1/1
1/2 +0.7
1/2 +0.3
1/2
1/4 ( +0.3,+0.7 )
1/8 ( +0.3,+0.7 )
1/16 ( +0.3,+0.7 )
1/32 ( +0.3,+0.7 )
1/64 ( +0.3,+0.7 )
1/128 ( +0.3,+0.7 )
Number of Flashes
30
40
50
60
100
200
300
500
1000
Power Output
1/1
1/2 ( +0.3,+0.7 );
1/4 ( +0.3,+0.7 )
1/8 ( +0.3,+0.7 );
1/16 ( +0.3,+0.7 )
1/32 ( +0.3,+0.7 );
1/64 ( +0.3,+0.7 );
1/128 ( +0.3,+0.7 );
Times
15
20
30
40
50
Meaning
Prompts on
LCD Panel
E1
E2
E3
E9
A failure occurs on the recycling system so that the ash
cannot re. Please restart the ash unit. If the problem still
exists, please send this product to a maintenance center.
The system gets excessive heat. Please allow a rest time of
10 minutes.
The voltage on two outlets of the ash tube is too high.
Please send this product to a maintenance center.
There are some errors occurred during the upgrading
process. Please use the correct rmware upgrade method.
Protection Function
1. Over-Temperature Protection
To avoid overheating and deteriorating the ash head, do not re
more than 20 continuous ashes in fast succession at 1/1 full power.
After 20 continuous ashes, allow a rest time of at least 10 minutes.
If you re more than 20 continuous ashes and then re more
ashes in short intervals, the inner over-heat protection function
may be activated and make the recycling time over 10 seconds.
If this occurs, allow a rest time of about 10 minutes, and the ash
unit will then return to normal.
When the over-heat protection is started, is shown on the
LCD display.