FP Zoom TTL - Wireless Flash Shooting: Radio (2.4 G) Transmission; Radio Transmission Positioning and Range; Radio Autoflash with One Slave; Radio Wireless Multiple Flash Setup

15
Use the supplied mini stand to position the slave unit.
Before shooting, perform a test ash and test exposures.
The transmission distance might be shorter depending
on factors such as positioning of slave units, interference
from other signals, barriers, bodies of water, and
weather conditions.
Wireless Flash Shooting: Radio (2.4G)
Transmission
Wireless Multiple Flash Shooting
Using a ash with a radio transmission wireless shooting makes it
easy to shoot with advanced wireless multiple ash setups, as well as
i-TTL autoash shooting.
The basic relative position and operating range are as shown in the
picture. You can then perform wireless i-TTL II autoash shooting just
by setting the master unit to < i-TTL >.
You can divide the slave units into two or three groups and perform
i-TTL autoash while changing the ash ratio. In addition, you can
set and shoot with a dierent ash mode for each ring group, for
up to 3 groups.
Transmission distance
is about 100m.
Autoash Shooting with One Slave Unit
Positioning and Operation Range
Auto Shooting with Two Slave Groups