FP Zoom TTL - Multiple Master Units and Wireless Modes; Manual Wireless Flash Shooting; Stroboscopic Wireless Flash Shooting

14
The ring frequency of stroboscopic ash during optical
transmission wireless shooting can be set from 1Hz to 100 Hz
(settings from 250 Hz to 500 Hz are not available).
Using Multiple Master Units
5. M: Wireless Flash Shooting with Manual Flash
By preparing several cameras with master unit ashes attached,
cameras can be changed during shooting while keeping the same
lighting source .
You can shoot with a dierent ash output setting for each slave
unit (ring group). Set all parameters on the master unit.
6. RPT: Wireless Flash Shooting with Manual Flash
Taking the picture.
Each group res at the set
ash power.
Setting the ash mode to <M>.
Press Function Button 4
< > to choose groups.
Then, press Function Button 3
< > to set the ash to
M mode.
Setting ash output.
Press Function Button 2
< >. Turn the Select
Dial to set the ash output of
the groups. Press the < SET >
button to conrm.
Setting < RPT > stroboscopic ash.
Press < MODE > button so that
< RPT > is displayed.
Set the stroboscopic ash.