06
Attaching to a Camera
Attach the Camera Flash.
Secure the Camera Flash.
Detach the Camera Flash.
Slip the camera ash’s
mounting foot into the
camera’s hotshoe all the way.
Rotate the lock ring on the
mounting foot until it is
secure.
Rotate the lock ring on the
mounting foot until it is fully
loosened.
Power Management
Use ON/OFF Power Switch to power the ash unit on or o. Turn o
the unit if it will not be used for an extended period of time. Set as a
master ash, it will turn the power o automatically after approx. 90
seconds of idle use. Pressing the camera shutter halfway or pressing
any ash button will wake up the ash unit. Set as a slave ash, it will
enter sleep mode after a certain period (adjustable, 60 minutes by
default) of idle use. Pressing any ash button will wake it up.
Disabling Auto Power O function is recommended
when the ash is used o camera.
See the Custom Function Menu section.
Slave Auto Power O Timer is set to 60 minutes by
default. Another option “30 minutes” is available.
See the Custom Function Menu section.
To Next Page
Loading...