FP Zoom TTL - Flash Modes Explained; i-TTL Autoflash and FEC

07
Press < MODE > Mode Selection Button to enter i-TTL(Automatic)
mode.
* Press < MODE > Mode Selection Button and three ash modes
will display on the LCD panel one by one with each press.
Flash Mode – i-TTL Autoash
i-TTL Mode
This ash has three ash modes: i-TTL, Manual (M), and RPT
(Stroboscopic). In i-TTL mode, the camera and the ash will work
together to calculate the correct exposure for the subject and the
background. In this mode, multiple TTL functions are available: FEC,
HSS, second curtain sync, modeling ash, etc.
Press the camera release button halfway to focus. The aperture
and eective ash range will be displayed in the viewnder.
When the shutter button is fully pressed, the ash will re a
pre-ash that the camera will use to calculate exposure and ash
output the instant before the photo is taken.
With FEC function, this ash can bias the ash output from -3 to +3
in 1/3rd stops. It is useful in situations where minor adjusting of the
TTL system is needed based on the environment.
FEC: Flash Exposure Compensation
Setting FEC:
Press Function Button 2
< >. The icon < >
and ash exposure
compensation amount
will be highlighted on the
LCD panel.
Turn the Select Dial to set the
amount.
“0.3”means 1/3 stop.
“0.7”means 2/3 stop.
To cancel the ash exposure.
compensation, set the amount
to “+0”.
Set the ash exposure
bracketing amount.
Press < SET > button again to
conrm the setting.