3
Please check the following steps carefully every time before fly.
1. Before use of the product, please accept some flight training (Using a simulator to practice flying, getting
instruction from a professional person, etc.).
2. Check that all parts of the Mariner are in good condition before flight. Do not fly with aging or broken parts.
3. Check that the propellers and the motors are installed correctly and firmly before flight. Make sure the rotation
direction of each propeller is correct. Do not get close to or even touch the working motors and propellers to avoid
serious injury.
4. Do not over load the Mariner should be less than 2000g.
5. Make sure that the transmitter battery and flight battery are fully charged.
6. Try to avoid interference between the remote control transmitter and other wireless equipment.
7. Make sure to switch on the transmitter first, then power on the Mariner before takeoff! Power off the Mariner
first, then switch off the transmitter after landing!
8. The fast rotating propellers of Mariner will cause serious damage and injury. Always fly the Mariner 3m or above
away from you and unsafe conditions, such as obstacles, crowds, high-voltage lines, etc.
9. All parts must be kept out of the reach of children to avoid CHOKEHAZARD; if a child accidentally swallow sany
part you should immediately seek medical assistance.
10. Please always keep the compass module away from the magnet. Otherwise it may damage the compass module
and lead the aircraft to work abnormally or even be out of control.
11. DO NOT use the Mariner transmitter (receiver) with the other third party remote control equipment.
12. Make sure to use the NAZA-M Lite assistant software V1.0 to carry out firmware upgrade and parameter
configuration.
13. The built-in ESCs of Mariner ONLY support up to 4S (14.8V) power supply.
14. ONLY use the FPVfactory original motor and 12-inch propeller.
15. If you want to put the Mariner in a car, please keep it away from the speaker, since the compass module may be
magnetized.
16. DO NOT use the magnetic screwdriver. Otherwise, keep the screwdriver at least 10cm away from the compass
module, to avoid magnetic interference.
17. If you use your own equipment(for example: GoPro3), please make sure the WiFi function is disabled, to avoid
the interference on the transmitter, which may cause the Marinre to FailSafe, crack and or even to fly away.
Cautions for Product Use
To Next Page
Loading...