Frank FC 711 M - User Manual

Questions and Answers

R
rhondabrownAug 17, 2025
What to do if my Frank Pressure Washer pump fails to reach prescribed pressure?
- C
  Curtis GriffinAug 17, 2025
  If your Frank Pressure Washer pump isn't reaching the pressure it should, start by checking for leaks in the water pressure suction hose and connecting pieces; tighten any loose screw connections, replace any worn sealings, and tighten the hose clips. Also, the pump seals might be leaking, in which case you should have an expert check the pump seals and plungers for wear and replace them if necessary. Ensure there's enough water supply and that the water filter isn't dirty; clean the filter if needed and provide a clean water supply. Lastly, make sure you're using the correct spray nozzle.
C
Crystal WilliamsAug 23, 2025
What to do if Frank Pressure Washer has abrupt pressure impulses?
- G
  Gabriella DavisAug 23, 2025
  If you're experiencing abrupt pressure impulses or the Frank Pressure Washer switches on and off when the spray gun is closed, there might be a leak in the pressure system. Check the pipes, fittings, pump connections, and spray gun for any leaks. Seal any leaky parts or have them replaced by an expert.
S
staceybushAug 29, 2025
How to fix excessive pump pressure on Frank Pressure Washer?
- D
  Debra LamAug 29, 2025
  If your Frank Pressure Washer has excessive pump pressure, the spray nozzle might be blocked. Try removing and cleaning the nozzle, then flush the spray lance without the spray gun. Also, ensure you are using the correct spray nozzle.
H
hernandezlisaSep 4, 2025
Why is there no flow of cleaning agents in my Frank Pressure Washer?
- E
  eharmonSep 4, 2025
  If there's no flow of cleaning agents in your Frank Pressure Washer, first check if the filter on the cleaning agent suction hose is blocked and clean it if necessary. Next, make sure the cleaning agent tank isn't empty and that the filter basket on the suction hose is below the liquid level; refill the cleaning agents and lower the filter basket if needed. If these steps don't resolve the issue, the injector might be contaminated, and you should have an expert clean it.
S
Sergio BondNov 10, 2025
Why does my Frank Pressure Washer not run or switch off during operation?
- R
  Rachel FreemanNov 10, 2025
  If your Frank Pressure Washer isn't running or shuts off, several factors could be at play. It could be due to no current or low voltage, in which case an expert should check the fuse, supply cable, wall socket, and voltage. The ON-OFF protective motor switch might be defective, requiring replacement by an expert. Excessive pump pressure could also cause the protective motor switch to cut out; refer to the section on 'Excessive pump pressure'. Other potential causes include used-up batteries in the spray gun (replace with type E-Block 9 V), a defective spray gun control electronics (have it replaced), interruption of the control line, a metallic short circuit (remove the connection or replace the insulating piece), a defective receiver (have it replaced), a torn weld joint on the battery h...