Franke AX937 DXA - Electronic Programmer Troubleshooting; Error Code Reference

To Next Page

To Previous Page

The oven is now programmed and in standby.

To check the set duration press the button

; to adjust it operate the buttons - OR + .

To check the set temperature press a button [-] or + ; to adjust it operate the knob C .

Cooking phase:

On reaching the cooking phase the oven behaves as in point B of the previous paragraph.Except that the cooking duration countdown starts immediately, and not

after the required temperature has been reached. This is because the controller assumes that the food has already been placed in the oven at the moment of

programming. The preheating time is included in the cooking time.

Failures and Error Codes ELECTRONIC PROGRAMMER ADVANCED

Whenever a failure is detected, a failure signal sounds and the display reads the belonging error code:

F3E3 Temp. sensor short circuit

F3E0 Temp. sensor open circuit

F4E0 EEPROM failure

At multiple errors, the display priority is as follows: F3E3, F3E0, F4E0.

The error message is automatically cleared when the failure is repaired. For EEPROM failure, the control has to be

reset first, for all other failures this can happen during program run.

At every failure, oven heating relay 1 is switched off.

Pos. COOKING Mode Display Preheat

0 Off hh:mm No