FRANKIA OPERATING MANUAL80 FRANKIA OPERATING MANUAL 81
A heating booster can optionally be connected to the hea-
ting circuit for additional hot air supply to the dashboard.
Two blower levels can be selected or the booster switched
off using the switch on the front passenger storage box.
Using the switch on the Alde heat exchanger pump you can:
preheat the engine cooling circuit, Use the residual heat
from the engine (to a limited extent) to heat the interior
We recommend that you drain the water from the water heater completely when you are not using your
motorhome. Turn the blue switch “A” by 90° to the position shown. To close the valve, turn switch “A”
again and then press button “B” on the base of the frost guard. If the valve automatically triggers when
there is a risk of frost, button “B” pops out.
6.4 Tables
Table extension:
• The table top is divided in the middle and fixed with magnets.
• Pull the tabletops apart sideways as far as they will go.
• Press firmly and in the centre on the lowered centre piece of the table with
your hand.
• The extension element now automatically rises to the level of the table top.
• Push the side table tops up to the centre piece so that it is magnetically
fixed again.
• For dismantling, proceed in the reverse order. Carefully press down the middle
table top segment until it locks in the lowered position.
Booster toggle switch
Heat exchanger, booster
Rotatable table base:
Depending on the floor plan, a rotatable table base is installed. By rotating the table 90°, the passage between the side
seating group and the table top can be increased. The table can be rotated steplessly without having to release a lock.
Fixed table base, lowerable:
The table consists of a fixed, lowerable table base and a continuously adjustable table top. By loosening the locks “A”
under the table top, the table top can be moved freely, for example to provide wider access to the cab. If the table top
is in the desired position, it can be fixed by folding up the locking lever (in the direction of the arrow). Before starting
the journey, the table top must be locked so that it cannot shift around bends or when the brakes are applied hard.
To lower the table, first raise the table slightly and push it down as far as it will go. Pull up to return to its position. To
convert the seating group into a supplementary bed (depending on the floor plan), two additional foot units must be
attached to the table top before it is lowered and provided with additional upholstery.
A
To Next Page
Loading...
