FRANKIA OPERATING MANUAL68 FRANKIA OPERATING MANUAL 69
4.10 Radio map or software update
A radio installed ex works already contains the current versions for navigation and firmware of the device. For a manual
update, please visit the manufacturer‘s website: www.alpine.de/support/software-und-kartenupdate.html and www.
alpine.naviextras.com
4.11 DSP amplifier with subwoofer - Source selection (Platin)
For Platin, a 4.1 DSP amplifier with subwoofer is integrated in the sound system. To change the audio sources radio or
TV, the corresponding setting must be selected on the rotary knob on the control unit and confirmed by pressing the
rotary knob.
The High level (H.LEVEL) setting must be selected for the radio audio source and the auxiliary (AUX) setting for the TV
audio source. If the sources are not selected as explained, there may be a humming sound on the speakers.
Furthermore, care should be taken to keep the volume on the TV in the upper half and then to set the overall volume
once via the control unit of the DSP subwoofer. Afterwards, the volume can then be changed as usual using the remote
control on the TV.
The control unit is located directly above the seating area on the wall.
5. SANITARY SYSTEM
5.1 Central supply (not with M-Line Neo)
Your motorhome is equipped with a central supply. All elements are stored together in a storage compartment (see
image).
• Open the storage flap of the supply and disposal
compartment, roll out the fresh water hose
• Switch on the water pump on the control panel
• Put a tap in the hot water position and open it com-
pletely - the boiler will now be filled
• As soon as the water comes out without bubbles,
close the tap again
• Repeat the process with all other hot water taps
• Open the taps in the cold water position until the
water comes out without bubbles - close all taps
again
For winter operation, please do not forget to empty the water in the hose completely. For this, the hose must be com-
pletely unrolled. If you do not use your motorhome for a long time, e.g. due to wintering, you can also remove the fresh
water hose reel and completely empty the water in the hose
Disassemble hose reel: Raise the hose reel, tilt slightly to take it out, Disconnect the adapter on the side
Assemble fresh water: Assemble in the reverse order
Central supply Fiat / MB (depending on floor plan)
Central supply MB / Fiat (depending on floor plan)
The ventilation hose does not serve as an overflow. When
filling the tank, always check the water level and stop the
water supply in time when it reaches 100%.
To Next Page
Loading...