What to do if Franklin Electric DC Drives show a Broken Pipe (BKPI) error?
If your Franklin Electric DC Drives display a Broken Pipe error, it typically indicates low pressure with high frequency. Check the piping for leaks and verify the parameter settings.
Why am I getting an auto-tuning error (AUE) on my Franklin Electric Cerus X-Drive DC Drives?
An auto-tuning error (AUE) on your Franklin Electric DC Drives can occur for several reasons. It may be due to an error during motor auto-tuning, in which case you should restart tuning. Other potential causes include no feedback current (check motor capacity and parameter settings), motor phase loss (Accel/Decel times too short), no load current or leakage inductance (check cabling between drive and motor).
How to fix a CAN bus off (CbFE) (CFrE) error on Franklin Electric Cerus X-Drive DC Drives?
A CAN bus off error on Franklin Electric DC Drives can stem from several issues related to CANopen communication. Start by checking the Comm card installation and communications settings. Also, inspect the wiring and grounding for possible interference, and ensure the communication circuit is wired in series. For a CFrE error, reset parameters and the station address.
What should I do if my Franklin Electric Cerus X-Drive show an Analog current input loss (ACE) error?
If your Franklin Electric DC Drives display an Analog current input loss (ACE) error, it could be due to an ACI loss, so check the ACI wiring. Also, check if the ACI signal is less than 4mA.
What does a braking fault (bF) mean on Franklin Electric Cerus X-Drive DC Drives?
A braking fault (bF) on Franklin Electric DC Drives indicates a brake resistor fault. If the fault code persists after pressing the “RESET” key, no answer.
How to resolve a CAN bus Add Err (CAdE) error on Franklin Electric Cerus X-Drive?
A CAN bus Add Err (CAdE) error on Franklin Electric DC Drives signifies a CANopen station address error. To resolve this, reset the address.
What causes a CAN bus Index Err (CIdE) error in Franklin Electric Cerus X-Drive DC Drives and how to fix it?
A CAN bus Index Err (CIdE) error in Franklin Electric DC Drives is due to a CANopen index error. To fix it, reset the index.
What does cc HW error (Hd0) mean on Franklin Electric Cerus X-Drive?
A cc HW error (Hd0) on Franklin Electric DC Drives indicates a Current Clamp detection error. Try cycling the power. If the fault code is still displayed on the keypad, no answer.
What is the cause of CPU Trap 0 error (TRAP) on Franklin Electric DC Drives?
A CPU Trap 0 error (TRAP) on Franklin Electric DC Drives is caused by a CPU instruction error. No answer.
Specifies the necessary ambient conditions for VFD installation and operation.
Covers best practices for VFD wiring, grounding, and noise reduction.
Details requirements for circuit breaker and fuse sizing.
Explains how to properly connect input power and motor output terminals.
Describes wiring for analog inputs, digital inputs, and communication.
Details VFD protection against over-torque conditions.
Explains protection against low load conditions like dry wells.
Setup and configuration for Modbus RTU protocol.
Setup and configuration for BACnet MS/TP protocol.
Guidance for diagnosing and resolving VFD faults and warnings.
A list of fault codes, their descriptions, and corrective actions.
Detailed reference for SET menu parameters and their functions.
Detailed reference for VFD menu parameters and their functions.
General| Brand | Franklin Electric |
|---|---|
| Model | Cerus X-Drive |
| Category | DC Drives |
| Language | English |
To Next Page
