SAFETY INSTRUCTIONS
Product Specific Precautions
6
Product Specific Precautions
High voltages capable of causing severe
injury or death by electrical shock are
present in this unit.
• Do not remove drive cover for wiring or periodic inspec-
tions while power is applied, or the unit is in operation.
• Capacitors inside the drive can still hold lethal voltage
even after power has been disconnected—ALLOW 5 MIN-
UTES FOR DANGEROUS INTERNAL VOLTAGE TO DIS-
CHARGE BEFORE REMOVING COVER OR WORKING WITH
INTERNAL COMPONENTS.
• Perform wiring after drive has been mounted. Otherwise,
electric shock or bodily injury can occur.
• Operate drive and control devices with dry hands.
• Do not use drive if power or motor cable is damaged.
• Do not apply power to a damaged drive or to drive with
missing parts.
• Do not use motor in swimming areas.
Risk of damage to drive or other equipment.
• Install and wire drive according to the instructions in this
manual.
• Take protective measures against ESD (Electrostatic Dis-
charge) before touching control boards during inspection,
installation or repair.
• This product is recommended for use with Franklin Electric
4-inch submersible motors as specified in this manual.
Refer to “
Common Specifications” on page 37. Use of this
unit with any other Franklin Electric motor or with motors
from other manufacturers may result in damage to both
motor and electronics.
• In applications where water delivery is critical, a replace-
ment pressure sensor and/or back-up system should be
readily available if the drive fails to operate as intended.
To Next Page
Loading...
Need help?
General
