UNPACKING AND INSPECTION
Transportation and Storage
9
UNPACKING AND INSPECTION
Transportation and Storage
The drive should be stored in the shipping carton or crate before installation.
Unpacking
1. Inspect exterior of package for shipping damage. If there is damage, notify the shipping agent and your
sales representative.
2. Make sure the part number and product ratings on the identification label are correct for the applica-
tion.
3. Remove drive from the box and check for damage.
4. Remove the drive cover and make sure the product ratings on the nameplate match the package label.
What’s in the Box
1. Variable Frequency Drive (VFD or “drive”)
2. Pressure Sensor and Boot (shown; transducer option not shown)
3. Sensor Cable
4. Screwdriver/Adjustment Tool
5. Strain Relief Fitting
6. Owner’s Manual
Risk of damage to drive or other equipment.
• Do not stack drive boxes higher than standard 48” cube height when palleting for storage.
• Do not place heavy items on drive.
• Do not drop drive or subject it to hard impact.
• Dispose of drive properly as industrial equipment waste.
Risk of personal injury or damage to drive or other equipment.
• Use suitable lifting equipment, in good condition, rated for at least 5 times the weight of the drive.
To Next Page
Loading...
Need help?
General
