TGA300 Rev180405
22
5. Press the PRESSURE button.
Result: P 1 0 4 ashes in the RPM display. The message display shows SET TIME
10:30AM .
6. To Change the Time: (If not, go to step 7.)
a. Press the MENU button.
Result: P 1 0 4 stops ashing. The message display shows the current time with
the AM or PM ashing.
b. Press the PRESSURE or RPM button to change AM or PM.
c. Press the MENU button.
Result: The minute ashes.
d. Press the PRESSURE or RPM button to change the minutes.
e. Press the MENU button.
Result: The hour ashes.
f. Press the PRESSURE or RPM button to change the hours.
g. Press and hold the SILENCE button to store new time.
Result: P 1 0 5 ashes in the RPM display. The message display shows NO
WARNING or LOGGED DATA. Go to step 8.
7. Press the PRESSURE button.
Result: P 1 0 5 ashes in the RPM display. The message display shows NO
WARNING or LOGGED DATA.
8. Press the MENU button when it shows LOGGED DATA or go to step 9.
Result: 5 1 ashes in the RPM display. The fault, date, and time that the fault code
was recorded shows in the message display.
a. To scroll through the logged fault code data, press the PRESSURE or RPM
button.
b. Press the SILENCE button to exit viewing logged data.
9. Press the PRESSURE button.
Result: P 1 0 6 ashes in the RPM display. The message display shows the engine type
code that is set in the program. (Refer to the Engine Code Reference Table, Document
Number XE-ECRTREF01-R0A.)
10 Press the PRESSURE or RPM button to scroll through the P-codes or press the SILENCE
button to exit the programming mode.
To Next Page
Loading...
Need help?
General
