FRC InView 360 HD AVM - Connecting ECU to Monitor and Second Device via CVBS

p. 13
AVM Around Vehicle Monitoring System Installation Guide
inView 360 HD Installation Guide
© Safe Fleet | July 2020 | All rights reserved
Document Number: XE-SNB100-C00-INSTALLPM-R0A
Connecting the ECU to a Monitor and a Second Device via the CVBS Connector
A Y-Splitter can be used to split the CVSB video line to connect either a Safe Fleet recorder or a second standard
resolution monitor�
Primary monitor
(Example monitor
shown)
CVBS
Additional hardware
required for connecting to
a Safe Fleet recorder or
additional monitor
Y-Splitter
OR
Safe Fleet Recorder
Second standard
monitor
 NOTE: Spacing the Calibration Pads
Be aware that if you congure the system to cut the video feed
when the vehicle reaches a certain speed (a safety feature that
removes the live video feed from the in-cabin monitor so that the
driver is not distracted), this will also affect the recorder� No video
will be recorded during that time�
 NOTE: Potential of Not Recording Video