Frecon FR100L-4T-0.7B

To Next Page

FR100L&FR200L For Wire drawing machine

- 1 -

Preface

FR100L&FR200L special purpose inverter is designed for wire drawing machine, based on the

core control arithmetic of FR100 or FR200 vector control inverter, combined with the control

requirements of wire drawing machine application. It can be widely used in water tank type wire

drawing host, water tank type winding machine, straight drawing machine and etc. Starting at any

position of lower-limit, point zero or upper limit on tension rod, tracking the speed automatically to keep

balance bar at the middle position, whenever without load, half load, full load, and whatever thick line,

thin line, low speed, high speed, the tension is constant.

When debugging the product, please refer to the commissioning guide in this manual,

maintenance can refer to FR100 or FR200 user manual.

IMPORTANT NOTES

◆To illustrate the details of the products，pictures in this manual based on products with outer

casing or safety cover being removed. When using this product, please be sure to well install

outer casing or covering by the rules, and operating in accordance with the manual contents.

◆The illustrations this manual for illustration only and may vary with different products you have

ordered.

◆The company is committed to continuous improvement of products, product features will

continue to upgrade, the information provided is subject to change without notice.

◆If you are using have questions, please contact our regional agents or our customer service

center. Customer Service Tel 0755 -33067999.

◆The company's other products please visit our website.http://www.frecon.com.cn

Main Page

Need help?

Do you have a question about the Frecon FR100L-4T-0.7B and is the answer not in the manual?

Summary

Preface

Chapter 1 Product Information

1.1 Nameplate Information

Details on the inverter's nameplate specifications and labels.

1.2 Model Selection Guide

Guide for selecting the appropriate FR100/FR200L drive model based on specifications.

1.3 Dimensions and Weight

Specifications for physical dimensions, installation requirements, and weight.

Chapter 2 Commissioning Guide

2.1 Wire Drawing Machine Diagrams

Diagrams illustrating wire and cable winding/unwinding for different machine types.

2.2 Main Circuit Terminals

Details on the inverter's main circuit terminal connections and functions.

2.3 Control Circuit Terminals

Details on the inverter's control circuit terminal connections and functions.

Chapter 3 Function Parameters

3.1 Basic Function Parameters

Covers system, frequency, start/stop, accel/decel, and digital input parameters.

3.2 Motor Parameters and Control Settings

Details motor parameters, V/f control, protection, status monitoring, and fault records.

3.3 Special Function Codes for Wire Drawing

Specific function codes for wire drawing machine applications, including H00 series.

Chapter 4 Troubleshooting

Overcurrent and Overvoltage Faults

Addresses faults related to overcurrent during acceleration, deceleration, and constant speed.

Power Supply and Motor Faults

Covers undervoltage, short circuit, power loss, and motor overload issues.

System and Communication Faults

Details faults related to module overheat, EEPROM, communication, and auto-tuning.

Wire Break and Other Faults

Covers wire break faults, hardware issues, and software compatibility errors.

Chapter 5 Parameter Setting Reference

Parameter Settings for Host Machines

Recommended parameter settings for water tank type wire drawing machine hosts.

Parameter Settings for Winding Machines

Recommended parameter settings for water tank type wire drawing winding machines.

Parameter Settings for Straight Line Machines

Recommended parameter settings for straight line wire drawing machines.

Parameter Settings for Unwinding

Recommended parameter settings for unwinding operations.