COMMISSIONING CHECKLIST
4.2
PRELIMINARY
___
Read owner's manuals
___
Check propeller, nut, cotter pin and zinc.
___
Install transducers
___
Close seacocks
___
Check all hose clamps and tighten as required
___
Touch up bottom paint
___
Install wheel
___
Dewinterize engine and heads, if so supplied
_
_
Check engine oil, transmission and coolant levels
___
Check battery charge with battery test switch on electrical
panel
___
Remove mast hole covers
___
Pre-rig masts - run halyards; install headstay, lazy jacks,
topping lift and mast collar
___
Cover the cushions or remove them from boat in order to
protect them during commissioning.
___
Mark prop shaft
LOOSE GEAR
___
Fenders w/lines ready
___
Dock lines ready
___
Winch handles
___
Ignition keys
___
Bilge pump handle
___
Install portlight screens
___
Sink strainers
___
Mast Wedges ready on mast
___
Mast retaining bolt ready
___
Stow remaining loose gear
To Next Page
Loading...