Freedom 30 - Engine Start

COMMISSIONING CHECKLIST
4.2-1
LAUNCH
__ ._ Check for leaks
___ Check operation of seacocks
___ Check stuffing box
ENGINE START
___ Read engine owner's manual
___ After launching, check alignment and hook up couplings
___ Start engine
___ Check exhaust for cooling water flow
___ Check oil pressure, water temperature, charging guages - stop
engine immediately if not in proper ranges per engine manual.
___ Check transmission operation
___ Check stuffing box
STEP MASTS
___ Pre rig masts w/halyards, lazy jacks, collar, alignment bolt, etc
___ Install electronics wiring in masts
___ Remove headliner trim pieces around mast opening in deck.
___ Hoist spar and lower carefully into boat
___ Install wedges while aligning masts
___ Install deck collars - place on mast prior to stepping mast
« ? Install overhead trim
-lOr—
___ Make electronical connections at mast base
RIGGING
___ Install boom and attach lazy jacks
___ Lead all sheets and halyards to stoppers on deck house
___ Rig reefs and vangs
___ Bend on sails
___ Install battens