EasyManua.ls Logo

freightliner CENTURY CLASS 2011 - M1 Maintenance Interval Operations

freightliner CENTURY CLASS 2011
193 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The M1 Maintenance Interval Operations tables list
all maintenance operations that are to be performed
at the M1 maintenance interval. Maintenance opera-
tion numbers are reference numbers used to help
you find detailed instructions in this manual on the
maintenance operations to be performed.
IMPORTANT: After performing all operations listed in
this table, perform all daily, weekly, and monthly
maintenance operations listed in the "Pretrip and
Post-Trip Inspections and Maintenance" chapter of
the Century Class® Driver’s Manual.
Maintenance
Operation Number
M1 Maintenance Interval Operations for Service Schedules I, II, and III Check
00–04 Lubrication and Fluid Level Check (includes the following):
Eaton Fuller Clutch Release Bearing Lubrication
Fifth Wheel Lubrication
Trailer Electrical Connector Lubrication
Suspension Lubrication
Knuckle Pin Lubrication, Dana Spicer Axles
Tie Rod Lubrication, Dana Spicer Axles
Driveline Lubrication
Dana Spicer Camshaft Bracket Lubrication
Dana Spicer, Haldex, and Gunite Slack Adjuster Lubrication
Cab Tilt Pump Reservoir Fluid Level and System Check
Door Seal, Door Latch, and Door Hinge Lubrication
Hood Rear Support Lubrication
13–01 Air Compressor Inspection
20–03 Fan Clutch Check (noise emission control)
31–01 Fifth Wheel Inspection
31–05 Premier 690 Coupling Inspection
33–11 Steer Axle Hub Cap Vent Plug Inspection
40–02 Tire Check
41–01 Driveline Inspection
42–07 Meritor Camshaft Bracket Lubrication
42–10 Brake Inspection
42–11 Versajust Slack Adjuster Inspection and Lubrication
*
49–01 Exhaust System Inspection (noise emission control)
*
Complete this procedure every 25,000 miles (40 225 km), 3 months, or 500 operating hours, whichever comes first.
Table 10, M1 Maintenance Interval Operations for Service Schedules I, II, and III
Maintenance
Operation Number
M1 Maintenance Interval Operations for Service Schedule IV Check
13–01 Air Compressor Inspection
20–03 Fan Clutch Check (noise emission control)
31–01 Fifth Wheel Inspection
General Information 00
M1 Maintenance Interval Operations: 00–06
Century Class Trucks Maintenance Manual, August 2017 00/11

Related product manuals