26
5.4.10 GPS data
Press the MENU button and then submenu „Fusion
Process“ to access „GPS data“. Activating/
switching on this menu will allow you to enter coor-
dinates/position of your fusion fitting. To determine
the GPS data you will need an appropriate device.
5.4.11 Seam number
The menu “Fusion sequence” is reached via the
guide button “MENU”. There you will find the
submenu “Seam number”. By activating the appro-
priate guide buttons you will be able to switch on or
off seam numbers entry.
5.4.12 Scraper tool
Press the MENU key and then submenu „Fusion
process“ to access „Scraper tool“. Activating/
switching on this menu will allow you to enter data
(e.g. unit number) of the scraper tool used for the
preparation of the fusion. For this facility the scraper
tool must have an appropriate barcode.
5.5 Menu „Data“
IMPOR
T
ANT!
The menu “Data” is activated (and thus made
visible to you) only once documentation is swit-
ched on and an initial set of data has been saved.
Press the MENU button to access the main menu.
Use the arrow buttons (up/down) to access sub-
menu „Data“ and select by pressing the START but-
ton.
5.5.1 Transfer
The guide button “MENU” will take you to the menu
“Data” with its submenu “Transfer”. Your
FRIAMAT
®
prime eco will recognise automatically
whether a PC/Laptop (with FRIATRACE database
software, version 5.1 onwards), a FRIATEC Memory-
Stick or a printer is connected.
FT_2377e_II_07_GB.qxd 13.02.2007 12:31 Uhr Seite 26
To Next Page
Loading...
