33
5.9.3 Info text, Comment 1, Comment 2,
Subcontractor
Depending on your selections, the following will
appear as part of the data programming prior to
fusion „INFO TEXT“, „COMMENT 1“, COMMENT 2“
and/or „SUBCONTRACTOR“. By pressing the
MENU button and using the arrow buttons (symbol
selection) you will be able to add any additional text.
The lines will be blank initially
, i.e. no additional text
is displayed (e.g. the text last entered). Use the
START button to save your entry and press it again
to continue preparing for your fusion.
IMPOR
T
ANT!
The additional text must be newly entered for
each fusion process, as no text will appear in
the report otherwise. If the START button is
activated immediately after reading in the fitting
barcode, no additional text is added to the
fusion.
5.9.4 Scraper tool
As part of the process of entering data to start the
fusion the request „SCRAPER TOOL: CODE“ – if
selected by you (see Section 5.4.12) – appears after
the prompt „PIPE PREPARED?“. If the scraper tool
which you used for the scraping of the pipe has the
appropriate barcode you will now be able to enter
this – this data will then be allocated to your fusion
in the report.
FT_2377e_II_07_GB.qxd 13.02.2007 12:31 Uhr Seite 33
To Next Page
Loading...
