Bucket Full Indicator
• This light glows when the water bucket is
full and needs to be emptied.
Power
• Operation starts when this button is
pressed and stops when the button is
pressed again.
Fan Speed
• This controls the speed of the airflow.
• High: Fan speed is set to high.
• Low: Fan speed is set to low.
• When Fan Speed button is pressed,
the fan speed mode is changed.
Timer
• Press this button to select type of operation.
• Select continuous for uninterrupted operation.
• Select either 2 or 4 Hr. On/Off for cycled
operation:
The unit will operate for 2 or 4 hours, and then
shut off completely for 2 or 4 hours.
The cycle repeats until you change the setting.
• When Timer button is pressed, the Timer
indicator lights shift as follows: Continuous ➔
2 Hr. On/Off ➔ 4 Hr. On/Off ➔ Continuous .
Humidity Control
• This button controls the humidity in the room.
• Press button to raise the humidity setting.
• Press button to lower the humidity setting.
• The humidity setting can be set to a permanent "On"
setting or to a specific humidity setting between 35% and
70% in 5% increments.
• "On" setting: Dehumidifier runs continuously regardless
of humidity condition.
• 35% - 70% setting: Dehumidifier runs on and off
according to surrounding humidity conditions.
Auto Restart
•
Once power is restored after a power outage, the unit
returns to its previous operation setting after a 2 minute
delay.
The fan runs immediately when the power is restored.
Figure 2
HUMIDITY
CONTROL
FAN
SPEED
TIMER
BUCKET
FULL
High
Low
Continuous
4Hr. On/Off
2Hr. On/Off
POWER
To Next Page
Loading...
Need help?
General
