Function and Control
Press this button to start the unit operation .Press this button again to stop the unit operation.
ON/OFF :
MODE :
Each time you press this button,a mode is selected in a sequence that goes from AUTO,
COOL,DRY, FAN,and HEAT
*
, as the following:
AUTO
COOL
DRY
FAN HEAT
*
*Note:Only for models with heating
function.
+ :
Press this button to increase set temperature.Holding down button above 2 seconds rapidly
Press this button to decrease set temperature.Holding down button above 2 seconds rapidly
.
FAN
:
Auto
Low speed
Medium speed
High speed
:
OFF
1
2
3
4
5
6
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not
be displayed on the LCD, and the unit will automatically select the suitable operation
mode in accordance with the room temperature to make indoor room comfortable.
increases set temperature. In AUTO mode, set temperature is not adjustable.
decreases set temperature. In AUTO mode, set temperature is not adjustable.
This remote controller is universal . If any command , or is sent out,
the unit will carry out the command as
indicates the guide louver swings as:
Every press of FAN button changes the fan speed in the following order:
Every press of the button changes the swing angle in the follow order:
To Next Page
Loading...
Need help?
General
