FriFri Basic 422 - 5.4 Programming and Frying Parameters

OPERATION
© frifri Aro SA 5-20 OM - 1.0 - 25.10.2004
5.6 Programming
5.6.1 “Basic” model
The “Basic” model of the deep fryer cannot be programmed.
Control element Explanations
Membrane switch “Program”
Press once to enter programming mode
“Programming knob”
Press:
- Entry into programming mode
- Confirmation to change the parameter
- Confirmation of changed parameter
Turn:
- Selection of parameter to change
- Change value of currently-selected parameter