Operating Instructions
Operating Instructions
4
.devreser sthgir llA.cnI ,stcudorP emoH xulortcelE 9002
Allow the unit to reach room temperature before operating.
To begin operating the dehumidifier, follow these steps:
1. Plug the power cord into a properly grounded 115 volt AC outlet.
If the "BUCKET FULL" light is on, remove the bucket and re-install to reset the float switch.
NOTE:
Unit must be upright for one hour prior to operating.
NOTE:
2.
3. After a few days when the Relative Humidity has declined, press the HUMIDITY or buttons to choose a value
between 35% to 85%, so the room is kept at a comfortable humidity. Pressing the or buttons will change the
humidity selection in 5% increments. After you have set the desired humidity, the readout will display the actual
room humidity. If at any time you want to return to the CONTINUOUS Mode, pressing the HUMIDITY button
will lower the Relative Humidity through the 5% decrements until the display reads CO.
To turn the unit on, press the ON/OFF button. The unit will run in the factory setting of CONTINUOUS and high fan
speed. In the CONTINUOUS mode, the unit will only display CO and not the room humidity. It is recommended you
leave the unit running in the CONTINUOUS setting for the first three or four days until the sweating and dampness
odors have stopped.
When unit is in operation, pressing and button will simultaneously for 3 seconds can lock buttons. If this function is
enabled, LOCK indicator will illuminate and display shows LC, which will blink for 3 times. Then room humidity will be display
again. To disable this function, press and button simultaneously for 3 seconds and the LOCK indicator will turn off.
CO
LC
To Next Page
Loading...
Need help?
General
