Frigidaire FFRS0833Q1 User Manual

READ BEFORE INSTALLING UNIT
For Slider Casement Air Conditioners
1
Installation Instructions
NOTE:
These instructions describe installation in a typical wood framed window with a wood SLIDE-BY sash, or
installation in a metal CASEMENT window. Modification may be necessary when installing in windows made
differently than those shown in these instructions.
WARNING:
Electrical ground is required on this appliance.
DO NOT ground to a gas line.
If cold water pipe is interrupted by plastic, non-metallic gaskets, or other insulating materials, DO NOT use for
grounding.
Check with a qualified electrician if you are in doubt as to whether the appliance is properly grounded.
DO NOT modify power supply cord plug. If it does not fit outlet, have a proper outlet installed by a qualified
electrician.
DO NOT have a fuse in the neutral or grounding circuit. A fuse in the neutral, or grounding circuit could result in
an electrical shock.
DO NOT use an extension cord with this appliance.
Meeting Electrical Requirements
OBSERVE ALL LOCAL GOVERNING CODES AND ORDINANCES. DO NOT, UNDER ANY CIRCUMSTANCES,
NOTE:
If codes permit, and a separate grounding wire is used, it is recommended that a qualified electrician determine
that the grounding path is adequate and not interrupted by plastic, non-metallic gaskets, or other insulating
materials.
be exposed:
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended
period of time.
Make sure air conditioner does not fall during installation.
Carefully read the installation manual before beginning.
Follow each step as shown.
INSTALLATION WARNINGS AND CAUTION

Frigidaire FFRS0833Q1 Specifications

General

Type	Window Air Conditioner
Cooling Capacity	8, 000 BTU
Voltage	115V
Room Size Coverage	350 sq. ft.
Operating Frequency	60 Hz
Fan Speeds	3
Filter Type	Washable
Installation Type	Window
Noise Level	56 dB

Summary

Installation Warnings and Caution

General Safety Precautions

Crucial safety guidelines and warnings for handling and installing the unit.

Meeting Electrical Requirements

Essential electrical standards and safety precautions for proper installation.

Receptacle and Electrical Specifications

Receptacle Wiring

Guidelines for proper receptacle wiring using copper wire.

Electrical Requirements

Specifies voltage, frequency, and amperage for the electrical supply.

Preparing for Installation

Installation Tips

Advice for installing in different window types like wood-frame or brick.

Tools Required

Lists all necessary tools for the installation process.

Installing Unit in a Sliding Window

Platform Assembly and Attachment

Steps for assembling and attaching the platform to the window.

Window Panel and Seal Installation

Instructions for installing the plastic window panel and side channel seals.

Securing the Unit and Sash

Methods for securing the unit and locking the window sash.

Installing the Unit in a Casement Window

Platform Attachment for Casement Windows

Instructions for attaching the platform to casement window jambs.

Window Panel and Seal Fitting

Guidance on cutting and fitting the window panel and seals.

Securing the Unit in Casement Opening

Steps to secure the unit and panel frame in the casement window opening.