EasyManuals Logo

Frigidaire FPID2498SF User Manual

Frigidaire FPID2498SF
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
19
BEFORE YOU CALL
Vapor at Vent
Spilled rinse aid can cause foam and lead to
overfl owing. Wipe up any spills with a damp
cloth.
Water vapor escapes fromt he vent during
the drying part of the cycle. This is normal.
Check to see that dishwasher is level. (See
Installation Instructions).
Dishwasher Won’t Run
Check to see if circuit breaker is tripped or if
a fuse is blown.
Make sure water supply is turned on.
Check to see if cycle is set correctly. (See
Operating Instructions).
Is dishwasher set for Delay Start Option?
Make sure door is closed and latched.
Dishwasher Won’t Fill
Is water supply turned on?
Dishwasher Does Not Drain Properly
If unit is hooked up to a food waste disposer,
make sure the disposer is empty.
Check to see if the knockout plug has been
removed from inside the food waste disposer
inlet.
Check to see if drain hose is kinked.
Make sure cycle is complete, not in a pause.
Dishwasher has an Odor
Soiled dishes left in dishwasher too long can
create an odor. Use Rinse Only cycle.
There will be a “new” smell when fi rst
installed. This is normal.
Check to see if unit is draining properly. (See
Dishwasher Does Not Drain Properly).
Opening the door during cycle
If the dishwasher door is opened while the
unit is running, the START/CANCEL pad must
be pressed and the door shut immediately
to return the unit to the selected cycle and
option.
Removing Spots and Film
Hard water can cause lime deposit buildup on the
interior of the dishwasher. Dishes and glasses
may also get spots and fi lm for a number of
reasons. (See Glassware/Flatware Spotted or
Cloudy section). To remove buildup, and fi lm,
clean using the following instructions:
1. Load clean dishes and glasses in normal
manner. Do not load any metal utensils or
silverware.
2. Do not add detergent.
3. Select the NORMAL cycle. Press START/
CANCEL pad. Close and latch the door.
4. Allow dishwasher to run until it starts the
second water fi ll (approximately 10 minutes).
5. Unlatch an and open door and pour 2 cups of
white vinegar into the bottom of dishwasher.
6. Close and latch door and allow cycle to fi nish.
Stains on Tub Interior
Washing large amounts of dishware with
tomato based soil can cause a pink/orange
appearance. This will not affect performance
and will gradually fade over time. Pre-rinsing
or using the Rinse Only cycle will reduce the
chance of staining. Using air dry option will
lessen staining.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Frigidaire FPID2498SF and is the answer not in the manual?

Frigidaire FPID2498SF Specifications

General IconGeneral
Stylebuilt-in dishwashers
Colorstainless steel
Load Capacity14
Number of Cycles7
Options/Settingsfeatures a variety of cleaning solutions like sanitize to help kill germs, rinse only to keep food from sticking to plates, and powerplus™ to clean crusty dishes with dried-on food
Drying Typeheated drying
Noise level47 decibels adjusted
Control Typebutton
Delay Startyes
Child Lockyes
Load Sensoryes
Number of Racks3
Cycle Signalyes
Food Disposeryes
Sanitize Settingsyes
Annual Energy Consumption260 kilowatt hours
Water Consumption Per Cycle8 gallons
Voltage120 volts
Current15 amperes
Weight and Dimensions IconWeight and Dimensions
Depth24.25 inches
Height33.75 inches
Width23.75 inches
Net Weight99.75 pounds

Related product manuals