FRIGOGLASS ISLIM - Installation & Operation; ICM Placement Instructions

ENG
9
3. Installation & Operation
Failure to comply with the instructions may result in high-energy
consumption, poor performance of the unit and void warranty.
 Keep all ventilation openings in the appliance enclosure or in
the built-in structure clear of obstruction.
 Do not use mechanical devices or means other than those
recommended by the manufacturer to accelerate the
defrosting process.
 Do not damage the refrigerant circuit.
 Do not use electrical appliances inside the food storage
compartments of the appliance, unless recommended by the
manufacturer.
 If the supply cord is damaged, it must be replaced by the
manufacturer, its service provider or similarly qualified persons
in order to avoid a hazard.
Do not place the merchandiser:
 in direct sunlight or near heat sources (radiators, stoves &
other heating equipment)
 outdoors, without proper protection from rain, moisture and
other atmospheric elements
 in climate conditions for which it is not certified
 in extreme environmental conditions (i.e. extensive exposure
to saline humidity)
3.1 ICM placement instructions
i.
After unpacking, check the cabinet for any damage caused during transportation. In t
he event of
damage, please
contact the forwarding company.
ii. Always ensure that your merchandiser is installed on a stable surface/floor. There ar
e 4
adjustable feet in ISLIM [R600a]. The cooler must
be leveled through prope
r adjustment of the
leveling feet in all installations. It
must be ensured that the cooler does not exhib
it any inclination
towards its front
side and/or its lateral sides, after adjustment. A slig
ht inclination toward its back
side will further facilitate the good circulation of the fluid and support the door closing
mechanism. The
use of a spirit level is highly advisable to che
ck leveling. Verify that the cooler
sits firmly on the leveling feet. The front cooler wh
eels (if available) should be able to
rotate by
hand after coole
r installation and adjustment. Take the necessary precautions if lifti
ng is required
during installation. Do not allow t
he access of unauthorized in
dividuals during the cooler
installation.
iii.
The merchandiser must stand upright for at least 1 hour after transportation and prior to start
-up.
This provides sufficient time for the oil to run back to the compresso
r after transit and
installation.
iv. Allow a minimum gap of 100mm a
t the back.