Dynamic 2100 Battery Strapping Tool Operation Manual | FPA001 | Apr 2018 | Page 1
1. GENERAL INFORMATION
Congratulations on the purchase of your Fromm Battery Powered Plastic Strapping
Tool. We trust you will have many years of packaging efficiency.
Before proceeding with the operation or installation of your new tool please read
this manual thoroughly and gain a full understanding of the requirements, features
and operation of your new tool.
1.1 Note of Installation
To ensure your tool operates in a safe manner please review the following
requirements:
1. Tool power is 14.4 Volt 3.0 Ah Li-Ion Battery.
2. Keep work area clean.
3. Tool can operate in temperatures between 5℃ and 45℃.
4. Please ensure you download and read our Install Guide before attempting it
yourself.
1.2 Notice of Operation
Before you start using the battery tool, please review the following conditions:
1. Before operating, please read the operational manual carefully.
2. Ensure the switch is in the off position before inserting the battery.
3. Avoid any damp object or water around the electric parts.
4. Recharge battery only with the charger specified by the manufacturer.
5. When a problem does occur, please check the troubleshooting section for more
information and advice.
To Next Page
Loading...