Dynamic 2100 Battery Strapping Tool Operation Manual | FPA001 | Apr 2018 | Page 7
3.7 Removing the Tool
Pull up the handle lever,
Pull the tool right/backwards and off the
strapping.
3.8 Seal - Control
A regular control of the seal is necessary. The seal can be examined visually. Make
a seal, peel it apart and examine it as follows:
Correct Seal
The seal must be completely welded over the
whole width of the strap on a length of ca. 25mm.
Minor quantities of fused plastic may overflow on
sides.
Welding Time Too Short
The plastic strap is not welded over the whole
width of the strap. The seal efficiency is
insufficient.
Warning! Straps with insufficient seal strength
must be removed from the package. Adjust the
welding time (see 3.2.2).
Welding Time is Too Long
If the welding time is too long the straps are
overheated. The fused plastic overflows on both
sides of the straps. The seal efficiency is affected.
Warning! Straps with insufficient seal strength
must be removed from the package. Adjust the
welding time (see 3.2.2).
3.9 Cleaning
Clean strap gripping parts from strap abrasion regularly using compressed air.
Do not use any mechanical tool for cleaning.
When cleaning the surface of the tool do not use water or aggressive solvents.
To Next Page
Loading...
