4
Strap Qualities
Polypropylene, plain or embossed
Polyester, plain or embossed
Seals
P404 / 16 MM Item No.: 41.5082
Joint strength
Depending on the strap quality the joint strength varies between 40 to 80 % of the breaking strength of the
strap.
Using low gauge straps, the joint strength is relatively high whereas high gauge straps tend to have a lower
joint strength.
Tension force
The tension force is calculated by the applied manual force multiplied by 10.
Thus the tension force is 200 N x 10= 2‘000 N if the applied manual force is 200 N at the tension lever.
When applying tension, the tension force must not exceed the breaking strength of the seal joint.
3 OPERATION ELEMENTS
Tension handle
Sealing lever
Lifting handle
Tensioning drum
Gripping jaw
To Next Page
Loading...
