18
General
Device concept Five cooling units are available for cooling
the power sources listed below:
- FK 4000 with oscillating armature
pump and auto-transformer
- FK 4000 R with centrifugal pump
- FK 4000 R FC with centrifugal pump
and flow sensor with coolant filter
- FK 4000 R US with centrifugal pump,
auto-transformer and flow sensor with
coolant filter
- FK 4000 Rob with magnetically-cou-
pled centrifugal pump, flow sensor with
coolant filter and thermostat
The cooling units described in these instructions can be operated with all power sources
in the:
- TransSynergic 4000 / 5000 series
- TransPuls Synergic 2700 series
- TransPuls Synergic 3200 / 4000 / 5000 series
- TransTig 2200 / 4000 / 5000 series
- MagicWave 1700 / 2200 / 4000 / 5000 series
Scope of supply - Cooling unit
- 5 l coolant in a canister
- Four Allen screws (for securing the power source on the cooling unit)
- Four M5 nuts (for securing the power source on the cooling unit)
- One 2 A fuse (spare)
- Operating instructions
Validity of "Gen-
eral Delivery and
Payment Condi-
tions"
With regard to cooling units, the "General Delivery and Payment Conditions" according to
the price list only apply under the following conditions:
- Max. 8 hrs/day operation (single-shift operation) / FK 4000 Rob: 24 hrs/day operation
(three-shift operation)
- Only original coolant from the manufacturer is used
- Regular maintenance and regular change of coolant
Information about
the coolant
CAUTION!
Risk of damage.
- Only use coolant available from the manufacturer.
- Do not mix different coolants.
- When changing the coolant, ensure to change all of it.
- When switching from ethanol-based coolant to FCL 10 coolant, Change Kit FCL10
must be used and the instructions provided must be followed.
To Next Page
Loading...
