31
EN
Fitting the cooling unit to the trolley
General The welding system can be fitted to a trolley to make the entire system more mobile.
NOTE!
If the welding system is not equipped with an auto-transformer, the cooling unit
must be installed right at the bottom.
Fitting the cool-
ing unit to the
trolley
Place the cooling unit on the trolley base and fixing bracket (1)
NOTE!
The fixing brackets must be placed within the plastic feet (2) of the cooling unit.
Secure the cooling unit to the fixing brackets using the four TX 25 screws provided (3),
two at the front and two at the back
(* Trolley scope of supply
(3)
(2)
(*
(1)
1
2
To Next Page
Loading...
