27
EN
Remove blanking covers (5) from the
front and attach to the rear
NOTE!
Fit the coolant return connection (1) at
the top and secure using the red plastic
nut (coolant return is indicated by red in-
sulating tape).
Feed the coolant connection (1) and
(2) from the inside outwards through
the housing and secure to the front of
the unit using the previously un-
screwed plastic nuts
Fit the side panel to the cooling unit and secure using three screws
(1)
(2)
(3) (4)
(5)
(5)
5
(1)
(2)
(5)
6
7
To Next Page
Loading...
