Fronius Selectiva Eco - Wall Mounting and Minimum Clearances; Mounting on the Wall; Optional Floor-Mounting Kit

3
Optional floor-
mounting kit
Washers
Screws, 2.9 x 13
Foot Foot
Retainers
Wall mounting and minimum clearances
1
3
5
4
5
2
> 30mm
> 30mm
> 15mm
> 15mm
Fig. 1 Charger with optional wall bracket (DIN rail
TS 35, EN 50022)
NOTE! If fixing to the wall, please note the weight of the charger. The bracket
must be fitted to a suitable wall using the correct dowels and screws.
Important! Observe minimum clearances for ventilation purposes. Ensure an adequate
supply of fresh air.
Fig. 2 Minimum clearances
Mounting on the
wall
Utilisation in
accordance with
„intended purpo-
se“
Important! Do not use this device to charge non-rechargeable batteries (dry batteries,
primary cells, etc.).
For charging liquid (Pb, Ca, Ca silver) or fixed (GEL, AGM, MF, sealant) electrolyte
batteries.