Need help?Do you have a question about the Fronius Selectiva Plus D and is the answer not in the manual?
General| Brand | Fronius |
|---|---|
| Model | Selectiva Plus D |
| Category | Battery Charger |
| Language | English |
The charger is manufactured according to recognized safety standards. Incorrect use can cause injury or death.
The charger is to be used exclusively for its intended purpose. Manufacturer is not liable for damage from misuse.
Operation and storage outside stipulated area is deemed as 'not in accordance with the intended purpose'.
Risk of electrocution from mains current, charging current, and hazardous electromagnetic fields.
Batteries contain acid. Gases/vapours released during charging are harmful and potentially explosive.
Protect batteries from dirt and damage. Store charged batteries in a cool place.
Keep persons, especially children, out of the working area and warn them about dangers.
Operate chargers with PE conductors on a mains supply with PE conductor and earth contact.
Operator must ensure no electromagnetic interference occurs in electrical and electronic devices.
Charger requires minimum care. Observe key points for long-term usability.
Warranty is 2 years. Manufacturer not liable for damage caused by improper use or non-compliance.
Operator must arrange a safety inspection of the device at least once every 12 months.
Do not dispose of device with normal domestic waste. Comply with European Directive 2002/96/EC.
EC marking and TÜV marks indicate compliance with relevant low-voltage and compatibility standards.
Copyright of operating instructions remains with the manufacturer. Subject to change without notice.
WARNING! Risk of injury and damage from exposed, rotating vehicle parts when working in the engine compartment.
Icons indicating disconnect charger from mains and connect machine to the mains.
Diagrams and list of numbered connections and controls on the front and rear of the charger.
Instructions for mounting the charger on the wall using optional wall brackets.
CAUTION! Ensure battery is functional before charging. Connect leads to battery poles.
Describes charging progress indication and the conservation charging phase.
Access parameters like current, voltage, capacity, and temperature via the Info button.
Press Start/Stop to interrupt or resume charging. Info button to view parameters.
CAUTION! Stop charging before disconnecting leads to prevent explosion risks.
The Info menu allows retrieval of current charger settings and status.
Disconnect battery leads. Press Info button for 5 seconds to access menu items.
Access up to 50 stored errors, displaying date of error and error number.
Retrieve details of the last 35 charging processes, including date and voltage.
WARNING! Options must be installed and operated by trained personnel.
Transfer charging data, statistics, and error logs to a PC via the integrated RS 232 interface.
Operate the charger using a remote display unit, mimicking the main panel functions.
Automatic battery water filling via solenoid valve, or signal lamp activation upon charge completion.
Use connections X 7/2 and X 7/5 to interrupt the charging process.
Adjusts charging voltage based on battery temperature for faster or gentler charging.
Mixes electrolyte by blowing air into the battery, reducing heating and water loss.
Provides a 10-pin socket for connecting a remote display or relay board.
Analyzes battery status (SOC, charging) and charger operation, connects to PLC/control systems.
Set parameters like charging characteristic, battery capacity, cells, temperature control, electrolyte circulation.
Access service levels 1 or 2 using buttons to navigate settings and save changes.
Configure charging characteristic, main voltage, delay time, and charging factor.
Configure start time, date, delay, pump program, and lead specifications.
Lists common error codes (e.g., ERROR 11-34), their causes, and remedies for troubleshooting.
Provides key technical specifications: mains voltage, output, charging parameters, protection, weight, and dimensions.
List of available spare parts with part numbers, descriptions, and specifications.
Important! Follow battery manufacturer's instructions. Do not connect battery during parameter setting.
Table listing charging parameters (I1, U1, I2) for various battery types (Nass/liquide, Gel, etc.).
Contact details for Fronius International GmbH and website for finding addresses of sales branches and partner firms.
To Next Page