Fronius TransTig 2600 Cel User Manual

Welding
1
Tilt the welding torch to the normal
position
Contact ignition Proceed as follows to ignite the arc:
Apply the gas nozzle
1
Position at the ignition point so that
there is a distance of approximately 2
to 3 mm (0.08 to 0.12 in.) between the
tungsten electrode and the workpiece.
Distance exists
Ignition through workpiece contact
1
Press torch trigger - shielding gas
flows
2
Gradually tilt the welding torch up until
the tungsten electrode touches the
workpiece
44

Fronius TransTig 2600 Cel Specifications

General

Brand	Fronius
Model	TransTig 2600 Cel
Category	Portable Generator
Language	English