Fronius TTB 160 G - Page 71

3
Open the protective bag:
- Push both zip pulls to the right as far as they will go
- Pull the bottom end of the tape out of the zip pulls
4
Place the interface connecting the extension hosepack and the torch hosepack in
the inside pocket of the protective bag
2
2x
*
*
A B
2
1
- * = Velcro strips on the inside pocket (inside pocket not shown)
- Secure the interface in the inside pocket with 2 Velcro strips
5
1
1
1
1
2
2
2
3
3
2
A B
- Route the coolant hose from the extension hosepack (A) to the interface as shown
- Wrap the coolant hose from the torch hosepack (B) around the torch hosepack 3
times and route to the interface
- Connect the coolant hoses
6
71
EN-US