37
EN
Connecting wire-feed unit to power source
Safety
WARNING!
Danger from electric current.
This can result in severe personal injury and damage to property.
► Turn the power source mains switch to the "O" position.
► Disconnect the power source from the mains.
► Ensure that the power source remains disconnected from the mains until all work has
been completed.
General informa-
tion
The wire-feed unit is connected to the power source using the interconnecting hosepack.
Connecting the
wirefeeder to the
power source
CAUTION!
Danger from electric current due to inadequate connections.
This can result in severe personal injury and damage to property.
► All cables, leads and hosepacks must be properly connected, undamaged, correctly in-
sulated and adequately dimensioned.
1 2
* only if the coolant connections are fitted in the wirefeeder and there is a water-
cooled interconnecting hosepack
NOTE!
Risk due to damaged connections.
This can result in serious damage to property.
► A strain-relief device is not provided for 1.2 m (3 ft 11.24 in.) interconnecting hose-
packs.
► During installation, make sure that the cables form a loop towards the inside (to the
wirefeeder) to avoid damage.
1
2
1
3
4
To Next Page
Loading...
